Brake Adjustment -> Brake System -> Service

Steps 1 - 5

Place the unit in service position.
Set both Transaxle Bypass Levers in the rear position.
Push unit forward.
- If unit does not move forward, no further action is needed.
- If unit easily moves forward, adjust the Brake Cable.
If the Brake Arm doesn't engage loosen Jam Nut towards rear of Cable Mount.
Tighten Adjustment Nut toward front of Cable Mount until the Brake Arm engages.

Steps 6 - 9

Tighten Jam Nut A.
If the control arm doesn't cam over fully, cable has been tightened too far, loosen Jam Nut B.
Loosen Jam Nut A until correct setting is achieved.
Tighten Jam Nut B.

Steps 10 - 11